Built-in Commands
timed_reset (Continued)
Examples:
traceroute
Description:
Syntax:
Options:
Example:
vrrpPort
Description:
Enables, disables, or displays the status of Virtual Router Redundancy
Protocol (VRRP) on front panel Ethernet or Fast Ethernet ports.
When the link on a VRRP Port goes down or up, the database is purged. Then
a notification is sent out to all LAN emulation clients (LECs) connected to the
local HSIM/VHSIM to clear their LEARP cache. Clearing the databases
causes the removal of old information and forces the SmartSwitch devices to
establish new virtual connections based on the new router paths.
12-38
Network Tools Screens
-> timed_reset status
timed_reset 10
-> timed_reset 30
-> timed_reset 60 reset_nv
Generates a TRACEROUTE request to a specified IP address and provides a
display of all next-hop routers in the path to the device. If the device is not
reached, the command displays all next-hop routers to the point of failure.
traceroute [IP address]
IP address — Specifies the IP address of a device to which the traceroute
will be generated.
-> traceroute 122.144.11.52
# next-hop[0]:122.144.60.45
# next-hop[1]:122.144.8.113
# next-hop[2]:122.144.61.45
# 122.144.11.52 is alive:3 hops away.
NOTE: This command is only valid when the switch supports the
installed HSIM or VHSIM.