Enterasys SmartSwitch 6000 User Manual page 161

Table 5-9 Flash Download Configuration Screen Field Descriptions (Continued)
Use this field...
Reboot After
Download
(Toggle)
TFTP Gateway IP
Addr
(Modifiable)
Download Server IP
(Modifiable)
Download File
Name
(Modifiable)
Last Image Server
IP
(Read-Only)
Last Image File
Name
(Read-Only)
Transfer Status
(Read-Only)
To...
Set the switch module so it will either reboot or not reboot after
completing the download of an image. This field toggles between YES
and NO, when the Download Method field is set to RUNTIME.
If YES is selected, the module reboots after the download is completed.
If NO is selected, the module continues using the existing firmware
image and stores the new firmware image in FLASH memory. The next
time the switch module is reset or powered-up, the module boots from
FLASH memory using the new image.
When the Download Method field is set to DOWNLOAD CONFIG,
the setting defaults to YES and cannot be changed. In UPLOAD
CONFIG, the setting defaults to NO and cannot be changed.
Enter the IP address of the TFTP gateway server defined on the
General Configuration screen in
Select the IP address of the TFTP server to be used for the download or
upload.
Select the complete TFTP server path and file name of the new image
or configuration file.
See the IP address of the server used for the previous download or
upload.
See the complete path and file name of the last downloaded image.
See the status of the current or most recent download or upload.
FLASH Download Configuration Screen
Section 5.2.4.
Module Configuration Menu Screens 5-35