Built-In Commands - Enterasys SmartSwitch 6000 User Manual

Refer to Table 12-1
Table 12-1 Built-In Commands
alias
bridge
ev
link_trap
non_bridge_if_num
radius
show
stpLegacyPathCost
suppress_topology_
traps
traceroute
1. The atm_stp_state command only displays when an HSIM or VHSIM is installed that supports ATM, such as the
HSIM-A6DP or VHSIM2-A6DP.
2. The gigabit_port_mode command only displays when a gigabit interface module is installed.
•
Special Commands – Allow the user to exit from Network Tools. The commands are done, quit,
and exit.
NOTES: The conventions used in describing the commands in Network Tools are as
follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in
bold font
.
To abort the output or interrupt a process, press the CONTROL key and c key
simultaneously, designated as ^C here.
The commands are presented in the following format:
for a list of the commands.
arp
cdp
gigabit_port_mode
loopback_detect
passiveStp
rate_limit_mode
soft_reset
stpPointToPointMAC
telnet
vrrpPort
arp_learn
defroute
2
igmpv3_drop
maclock
ping
reset
stpEdgePort
stpPort
timed_soft_reset
Network Tools
atm_stp_state
dynamic_egress
lg_frame_admin
netstat
policy
sat_size
stpForceVersion
stpRealTimeMsgAge
timed_reset
Network Tools Screens
1
12-3