Using The Fluidmax Management Setting - Cisco FM1200 Installation And Configuration Manual

Figure 34. Configurator (Advanced Radio Settings)

Using the FluidMAX Management Setting

The FluidMAX™ Management controls are used to set the unit's
FluidMAX™ operating mode.
Note that the FluidMAX™ Management controls are only available under
the following conditions:
• If the unit's firmware is equipped with the FluidMAX engine.
• If the unit is currently being operated as part of a point-to-multipoint
network topology.
To use the FluidMAX Management menu, do the following steps:
1. Click the Radio Mode drop-down menu.
2. Choose the correct FluidMAX operating mode from the following
list of options:
• AUTO: The FluidMAX engine is enabled, and the unit role
is set automatically. Depending on various factors, the unit
will automatically choose whether to transmit using the
time-division multiple access (TDMA) protocol or the
carrier-sense multiple access (CSMA) protocol.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Page 93 of 175