Plug-In Management - Cisco FM1200 Installation And Configuration Manual

Figure 56. Configurator
UPGRADE dialog)
7. Upload the firmware image file to the unit by clicking the Choose
File button and following the software prompts.
• The Upgrade button will become available.
8. Click the Upgrade button. Follow the software prompts until the
firmware overwrite is complete.
• When the overwrite is complete, the unit will automatically
reboot.
If the previous firmware was overwritten with a newer version of firmware,
check that the firmware upgraded correctly by doing the following steps:
• When the overwrite is complete, make sure that the upgraded
firmware has a greater version number than the firmware that
was previously installed.
• If the firmware version has not changed, the firmware
upgrade has failed. Repeat the overwrite from step
above.

7.7.4. Plug-In management

IMPORTANT
For a complete list of software plug-ins that are currently
available for the Cisco FM1200 Volo, refer to
ins" (page
The MANAGE PLUG-INS page shows which software plug-ins are
currently active on the unit, and contains controls that allow you to do the
following functions:
• Upload activation codes that allow the unit's accessory software
plug-ins to function.
• Activate uploaded software plug-ins for use with the unit.
• Deactivate uploaded software plug-ins so they can be used on
other Cisco units.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
GUI
141).
(typical FIRMWARE
Step 1
"Available plug-
Page 130 of 175