Vlan Settings; Vlan Configuration - Cisco FM3200 Base Installation And Configuration Manual

3. When the L2TP configuration has been set, save the settings by
clicking the Save button. Alternatively, clear the settings by
clicking the Reset button.
IMPORTANT
A detailed description of L2TP configuration methods is
beyond the scope of this manual. For detailed instructions on
how to set the L2TP configuration, refer to the Cisco
Networks L2TPv3 Configuration Manual.

6.6.11. VLAN settings

VLAN configuration

The VLAN SETTINGS window contains controls to connect the Cisco
FM3200 Base to one or more virtual local area networks (VLANs) that are
part of the local wireless network.
IMPORTANT
The VLAN feature must be enabled using a software plug-in
(Cisco part number FM-VLAN). Contact your Cisco
Networks representative for details.
The Cisco FM3200 Base features smart self-management of integration
with connected VLANs, with minimal configuration time and avoidance of
potential configuration errors. This is done by A) relying on the data-
processing configuration of a connected network switch, and B) obeying
predefined rules for management of incoming and outgoing data packets.
IMPORTANT
For detailed information on the predefined rules for smart
VLAN packet management, refer to the
management" (page 116)
To connect the unit to a VLAN that is part of the local wireless network, do
the following steps:
1. Click the
left-hand settings menu.
• The VLAN SETTINGS dialog will be shown
(page
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
table at the bottom of this section.
-vlan settings link under ADVANCED SETTINGS in the
116)).
"Rules for packet
(Figure 50
Page 115 of 176