Table of Contents
Advertisement
Fluidmesh 1200 VOLO
4.
If needed, enter the host name of a chosen secondary NTP
server in the Secondary NTP server (optional): field.
5.
Select the time zone in which the unit is installed by clicking
the Select Timezone: drop-down menu and clicking the correct
time zone option.
6.
Save the NTP settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
7.6.10. L2TP configuration
Layer 2 Tunneling Protocol (L2TP) functionality allows Fluidmesh radio
transceivers to support integration with virtual private networks (VPNs).
Fluidmesh hardware devices are shipped from the factory with L2TP
functionality disabled. To change the unit's L2TP settings, do the following
steps:
1.
Click the -l2tp configuration link under ADVANCED SETTINGS
in the left-hand settings menu.
Figure 55. Configurator GUI (L2TP Configuration dialog)
• The L2TP Configuration dialog will be shown
2.
To enable L2TP functionality for the unit, check the L2TP check-
box.
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The
L2TP
configuration
the Fluidmesh 1200 VOLO is set to Mesh Point mode or Mesh
End mode. If the unit is set to Bridge mode, the -l2tp
configuration menu option will not be available.
The L2TP feature must be enabled using a software plug-in
(Fluidmesh part number FM-L2TP). Contact your Fluidmesh
Networks representative for details.
(page
110)).
option
is
only
available
Page 110 of 169
if
(Figure 55
Advertisement
Table of Contents
