Setting The Vehicle On The Centre Support Stand - APRILIA RSV mille 956X Service And Repair Manual

GENERAL INFORMATION
1.9.4 SETTING THE VEHICLE
ON THE CENTRE SUPPORT STAND
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
cod. 8140176 (complete stand).
Remove the lower fairing, see 7.1.32 (REMOVING
THE LOWER FAIRING).
Set the vehicle on the relevant front support stand, see
1.9.3 (SETTING THE VEHICLE ON THE FRONT SUP-
&
PORT STAND ).
Hold the nut on the inside (1) still.
Unscrew and remove the engine upper rear fasten-
ing screw (2).
Driving torque of nut (1) / screw (2): 50 Nm (5.0 kgm).
NOTE
The screw (2) on the left-hand side is longer.
Retrieve the nut (1).
Insert the upper right support pin (3) in the upper hole
on the right-hand side.
Insert the stud bolt (4) in the upper hole on the left-hand
side and screw it all the way onto the pin (3).
Screw the upper left support pin (5) all the way onto the
stud bolt (4) and tighten.
Hold the nut on the inside (6) still.
Unscrew and remove the engine lower rear fasten-
ing screw (7).
Driving torque of nut (6) / screw (7): 50 Nm (5.0 kgm).
NOTE
The screw (7) on the right-hand side is longer.
Insert the lower right support pin (8) in the lower hole on
the right-hand side.
Insert the stud bolt (9) in the lower hole on the left-hand
side and screw it all the way onto the pin (8).
Screw the lower left support pin (10) all the way onto
the stud bolt (9) and tighten.
Place the support bracket (11) with the longer side of the
base facing forwards, on the two support pins (5 - 10).
Insert the two washers (12 - 13) and two nuts (14 - 15),
screwing them on by hand.
Tighten the two nuts (14-15).
Place the support bracket (16) with the longer side
of the base facing forwards, on the two support pins
(5 - 10).
Insert the two washers (17 - 18) and two nuts (19 - 20),
screwing them on by hand.
Tighten the two nuts (19 - 20).
Remove the front and rear support stands.
1 - 18
&
RSV mille