Assembling The Pins For The Rear Support Stand; Placing The Vehicle On The Rear Support Stand - APRILIA TUONO 1000 - 2006 Manual

1
ASSEMBLING THE PINS FOR THE
REAR SUPPORT STAND
Place the vehicle on the stand, see
page 77 (PLACING THE VEHICLE ON
THE STAND).
Place the pin (1) on the appropriate
seat on the swingarm.
Insert and tighten the screw (2) in the
appropriate threaded hole (3) in the
swingarm.
3
1
4
2
PLACING THE VEHICLE ON THE
REAR SUPPORT STAND
Assemble the pins for the rear support
stand
THE PINS FOR THE REAR SUPPORT
STAND
NOTE
Have someone help you keep the
vehicle vertical with the two wheels on the
ground.
1
4
, see above (ASSEMBLING
).
4
5
Slacken the knob (5).
Shift the fork-shaped support (4) so
that its width matches the distance
between the two pins (1) fitted to the
swingarm.
Tighten the knob (5).
Slide both fork-shaped seats (4) of the
stand (6) underneath the pins (1) fitted to
the vehicle simultaneously.
Place one foot on the rear end of the
stand (6).
Push the stand (6) downwards until it
reaches the end of its stroke (see figure).
WARNING
Make sure that the vehicle is stable.
If it falls over, it may cause damage to
bystanders and other property, as well
as being damaged itself.
use and maintenance TUONO 1000
1
6
99
USA