Inspecting The Driving Chain Guide Plate; Inspecting The Driving Chain Shoe - APRILIA RSV mille 956X Service And Repair Manual

RSV mille
2.35.5 INSPECTING THE DRIVING CHAIN GUIDE
PLATE
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
Position the vehicle on the stand.
Remove the lower fairing, see 7.1.32 (REMOVING
THE LOWER FAIRING).
Remove the clutch lever, see 3.2.2 (REMOVING THE
GEARSHIFT PEDAL).
Remove the clutch control cylinder, see 3.2.3 (REMOV-
ING THE CLUTCH CONTROL CYLINDER).
Unscrew and remove the three screws (1).
Driving torque of screws (1): 12 Nm (1.2 kgm).
NOTE
Release the cable of the side stand switch from
the clip.
Remove the pinion protection case (2).
Remove the guide plate (3).
Make sure the guide plate (3) is not worn or damaged;
if so, replace with a new one.

2.35.6 INSPECTING THE DRIVING CHAIN SHOE

Position the vehicle on the stand.
Make sure the shoe (4) is not worn or damaged; if so,
replace with a new one, see 7.1.51 (REMOVING THE
DRIVING CHAIN SHOE).
SERVICE AND SETTING UP
3
4
2 - 45