Clutch Cover; Support Bushes - APRILIA RSV mille 956X Service And Repair Manual

ENGINE

3.6.19 CLUTCH COVER

Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
Check the gasket surface for signs of damage and
check the whole thread to make sure it is in a perfect
state of repair.
Check the support bushes of the driving shaft (1) and
countershaft (2) for signs of rolling or grooves.
Measure the diameter of the two support bushes.
– Driving shaft bushes:
wear limit Ø 30.040 mm.
– Countershaft bushes:
wear limit Ø 20.060 mm.
a
CAUTION
Take a number of measurements, especially in the di-
rection of the axis of both cylinders.
None of the values must exceed the limit value.
Measure the radial play of the driving shaft and coun-
tershaft, see 3.6.5 (ENGINE HALF-CASING - MAIN
BUSHES, DRIVING SHAFT AND COUNTERSHAFT).

3.6.20 SUPPORT BUSHES

Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
DISASSEMBLY
Mark the contact surface (3) of the two bushes on the
clutch cover.
NOTE
Have the appropriate special tool
(cod. 8140156 + 8140157 + 0276377 - clutch cover
sleeve puller).
Remove the main bushes with the special tool (4).
a
CAUTION
As a rule, the main bushes should all be replaced to-
gether.
3 - 62
&
(4) to hand
RSV mille