APRILIA RSV mille 956X Service And Repair Manual page 234

RSV mille
 2%-/6).' 4(% &),,%2 .%#+
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.5 (COOLANT).
Drain the cooling circuit completely, see 2.16 (CHANG-
ING THE COOLANT).
NOTE
Obtain appropriate pliers to attach the clamps,
or screwdriver-type pipe clamps to replace the original
ones (special type without screw).
Release the head off the pipe clamps (1-2).
Pull the pipe (3) off the neck (4).
Pull the coupling (5) off the neck (4).
a
CAUTION
Plug the coupling openings so as to prevent any for-
eign bodies falling in.
Move the pipe clamp (6).
Pull the pipe (7) off the neck (4).
Unscrew and remove the screw (8) and retrieve the
bush.
Remove the filler neck (4).
 2%-/6).' 4(% 4(2%% 7!9 -!.)&/,$
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.5 (COOLANT).
Turn the ignition switch to position "
Lift the fuel tank, see 2.8 (LIFTING THE FUEL TANK).
Remove the engine oil tank, see 7.1.49 (REMOVING
THE ENGINE OIL TANK).
Drain the cooling circuit completely, see 2.16 (CHANG-
ING THE COOLANT).
Disconnect the electric connectors (9-10) from the ther-
mal switch (11).
a
CAUTION
When reassembling, make sure the electric connec-
tors (9-10) are plugged in properly.
NOTE
Obtain appropriate pliers to attach the clamps,
or screwdriver-type pipe clamps to replace the original
ones (special type without screw).
Release the head off the pipe clamps (12-13-14).
Pull the three pipes (15-16-17) off the manifold (18).
Loosen the pipe clamp (19) and move it downwards.
Grip the manifold (18) and slide it up off the coupling
(20) one small step at a time.
a
CAUTION
Plug the coupling openings so as to prevent any for-
eign bodies falling in.
Where necessary:
Unscrew and remove the thermal switch (11) and re-
trieve the gasket.
NOTE
When reassembling, apply LOCTITE
the thread of the thermal switch.
Driving torque of thermal switch (11): 30 Nm (3.0 kgm).
m
" .
®
572 on
COOLING SYSTEM
6
7
9
11
10
17 16 14
15 12
18
19
20
1
3
4
8
2
5
13
5 - 9