APRILIA RSV mille 956X Service And Repair Manual page 212

RSV mille
NOTE
Obtain appropriate pliers to attach the clamps,
or screwdriver-type pipe clamps to replace the original
ones (special type without screw).
Release the head off the pipe clamps (9 - 10).
Pull the pipes (12 - 13) off the throttle body (11).
Disconnect the two throttle cables (14 - 15).
a
CAUTION
When reassembling, make sure the two throttle cable
adjusters are properly fastened to the respective cou-
plings and check and, where necessary, restore the
correct freeplay, see 2.11.3 (ADJUSTING THE ACCEL-
ERATOR CONTROL).
Disconnect the cold-start control cable (16).
a
CAUTION
When reassembling, make sure the cold-start control
cable adjuster is properly fastened to the respective
coupling and check and, where necessary, restore
the correct freeplay, see 2.12 (COLD START CABLE).
Loosen the two clamps (17 - 18).
a
CAUTION
When removing the throttle body (11), be careful to
make sure it remains connected to the fuel tank (20)
by means of the fuel pipe (19).
Grip the throttle body (11) firmly and hitch it one way
and the other to lift it and slide it off the intake flanges.
Place the whole throttle body (11) and fuel tank (20),
still connected together, on a clean surface.
a
CAUTION
When reassembling:
– the fuel delivery pipe (19) must not be entangled or
positioned where it is likely to be squashed by oth-
er components; should it appear damaged or dete-
riorated, it must be replaced;
– the fuel delivery pipe (19) must be placed so that it
reaches the right-hand side of the throttle body
(11), passing under said body between the two in-
take flanges;
– the throttle body (11) must be fitted perfectly on
the intake flanges;
– the clamps (17 - 18) must be properly tightened.
FUEL SUPPLY SYSTEM
4 - 13