APRILIA RSV mille 956X Service And Repair Manual page 92

RSV mille
Unscrew and remove the screw (5) and disconnect the
cable from the "neutral" gear switch (6).
Move the protection element (7) aside and disconnect
the cable from the engine oil pressure sensor (8).
Move the protection element (9) aside, unscrew and re-
move the nut (10), recover the washer and disconnect
the starter motor cable.
Remove the rear brake lever and relevant mount (11),
see 7.1.46 (REMOVING THE REAR BRAKE LEVER).
a
CAUTION
Move the mount (11) and secure it in place, taking ex-
treme care as it remains connected to the electric ca-
ble by means of the brake light switch (12).
Remove the rear brake pump (13), see 7.6.4 (REMOV-
ING THE BRAKE PUMP).
a
CAUTION
Move the rear brake pump (13) and secure it in place,
taking extreme care as it remains connected to the
brake fluid pipes.
The brake fluid tank (14) must be held vertically to
prevent the fluid spilling out.
Remove the clutch control cylinder, see 3.2.3 (REMOV-
ING THE CLUTCH CONTROL CYLINDER).
Remove the drive pinion, see 7.1.51 (REMOVING THE
DRIVING CHAIN SHOE).
Remove the gearshift lever, see 3.2.2 (REMOVING
THE GEARSHIFT PEDAL).
Remove the expansion tank, see 5.9 (REMOVING THE
EXPANSION TANK).
ENGINE
3 - 9