APRILIA RSV mille 956X Service And Repair Manual page 24

RSV mille
 ).3425#4)/.3 &/2
!00,9).' 42!.3&%23
When removing parts of the frame :
a
CAUTION
Handle plastic and painted parts carefully so not to
scratch or damage them.
Perform the work with the utmost care.
Do not damage the tabs and/or the slots into which
they are inserted.
When applying the transfers, follow the instructions given
below carefully.
It is advisable to use the following tools:
– relatively stiff spatula (1);
NOTE
Generally, soft, squeegee-type spatulas do not
remove enough water from under the transfer.
– sponge or sprayer (2) with water.
NOTE
Add detergent to the water (1 - 3%) and shake
until you get soap bubbles.
Apply as follows:
Place the transfer (3) upside down on a work surface.
Keeping the transfer spread out on the work surface,
remove the protective backing (4) completely.
NOTE
It is advisable to use a sprayer (2).
When using a sponge, dab the surface with the sponge,
without pressing hard so as to avoid damaging the adhe-
sive.
Wet the surface of the adhesive with soapy water.
Apply the transfer (3) on the surface to be decorated
and move it into the right position.
NOTE
Always move the spatula in constant strokes
from the centre of the transfer out.
Using the spatula (1), press down reasonably hard and
move the spatula across the surface of the transfer until
the excess soap and water has been removed from un-
derneath.
NOTE
Do not lift the corners and/or sides of the trans-
fer.
Use an absorbent cloth and, working from the centre
out, dry the transfer.
Move the spatula over the transfer again with firm, even
strokes, pressing down as hard as possible.
Move the spatula in strokes from the centre out, taking
special care with the corners and sides to make sure
the whole surface sticks evenly.
GENERAL INFORMATION
1 - 19