Engine
Removing the clutch cover
•
Undo and remove the side fixing
screws.
•
Remove the clutch cover.
It is advisable to remove only the clutch cover in
order to replace the clutch discs. Should the com-
plete clutch assembly be removed, remove the
crankcase, clutch side.
It is however possible to remove the complete
clutch assembly by removing only the clutch cover.
In this case carry out the following operations:
•
measure the clutch bell protrusion from
the crankcase before removal;
•
during refitting, first check that the
measurement has not changed, then
tighten the clutch nut. If it has changed,
rotate the crankshaft so that the oil
pump control drive gear engages cor-
rectly with the oil pump driven gear on
the clutch bell.
ENG - 14
SL 750 SHIVER