Daikin Perfera RXM R Series Service Manual page 180

3 | Components
To install the swing flap motor
To remove the swing flap motor wiring harness
To install the swing flap motor wiring harness
Service manual
180
1 Install the coupling piece on the swing flap motor. Install the spring to fix the
coupling piece.
2 Connect the wiring harness to the swing flap motor.
3 Install the swing flap motor in the correct location on the indoor unit.
a Swing flap
b Screw (swing flap motor fixation)
c Swing flap motor
d Coupling piece
4 Install and tighten the 2 screws to fix the swing flap motor.
5 Install the swing flap.
6 Install the switch box, see
Is the problem solved?
Yes
No
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Remove the switch box, see
2 Disconnect the wiring harness from the swing flap motor.
3 Remove the swing flap motor wiring harness from the indoor unit.
4 To install the
4
procedures" [ 179].
1 Connect the wiring harness connector to the swing flap motor.
2 Install the switch box, see
Is the problem solved?
Yes
a d
b c b
"3.14 Plate work" [
Action
No further actions required.
Return to the troubleshooting of the
specific error and continue with the
next procedure.
"3.14 Plate work" [
swing flap motor
"3.14 Plate work" [
Action
No further actions required.
RXM20~71R + ARXM25~71R + FTXM20~71R + ATXM25~50R +
4
151].
4
"3.14 Plate work" [ 151].
4
151].
wiring harness, see
4
151].
Split New Perfera R32
ESIE20-11 – 2021.01
"Repair
FVXM25~50A