Installing The Ptx5000 Mounting Hardware For An Open-Frame Rack; Installing Cage Nuts, If Needed; Figure 33: Center-Mounting Bracket Removal - Juniper PTX Series Hardware Manual

Installing the PTX5000 Mounting Hardware for an Open-Frame Rack

Installing Cage Nuts, If Needed

Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing the PTX5000 Packet Transport Switch Mounting Hardware

Figure 33: Center-Mounting Bracket Removal

Center-mounting bracket
Installing Cage Nuts, If Needed on page 71
1.
Installing the Open-Frame Rack Mounting Shelf on page 73
2.
Insert cage nuts, if needed, into the holes listed in
page 72. The hole distances are relative to the standard U division on the rack that is
aligned with the bottom of the mounting shelf and rear support bracket.
To install cage nuts in an open-frame rack:
On the rear side of both rack rails, insert cage nuts in the holes specified for the
1.
open-frame mounting shelf (see
On the front side of both rack rails, insert cage nuts in the holes specified for mounting
2.
the chassis (see Table 29 on page
Table 28 on page 72
Table 28 on page 72).
72).
and Table 29 on
71