Ptx5000 Fpcs Supported; Ptx5000 Host Subsystem Description; Table 15: Fpcs Supported By The Ptx5000 Packet Transport Switch - Juniper PTX Series Hardware Manual

Related
Documentation

PTX5000 FPCs Supported

Table 15: FPCs Supported by the PTX5000 Packet Transport Switch

FPC Type FPC Name
5 FPC5
Related
Documentation

PTX5000 Host Subsystem Description

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.
Table 14: PTX5000 FPC LEDs (continued)
Label Color
Red
FAULT
–
PTX5000 FPC Description on page 32
Maintaining the PTX5000 FPCs on page 111
Troubleshooting the PTX5000 FPCs on page 136
Table 15 on page 35 lists the FPCs for the PTX5000 Packet Transport Switch. First Junos
OS Release Supported indicates the first release that the FPC is supported in the packet
transport switch.
FPC Model
Number
FPC-PTX-P1-A
PTX5000 FPC Description on page 32
The host subsystem provides the routing and system management functions of the
packet transport switch. You can install one or two host subsystems. A host subsystem
consists of a Routing Engine installed directly into a slot in a control board. To operate,
each host subsystem functions as a unit; the Routing Engine requires the corresponding
control board, and vice versa.
NOTE: We recommend that you install two host subsystems for redundant
protection.
Each host subsystem has three LEDs, located on the upper left of the craft interface,
which display the status of the host subsystem. In addition, there are LEDs on each
Routing Engine and control board.
PTX5000 Craft Interface LEDs on page 28
PTX5000 Control Board Description on page 22
Chapter 3: PTX5000 Hardware Components Overview
State Description
On steadily FPC has failed.
Off FPC is offline .
Maximum
Maximum Throughput per
Number of PICs FPC
2 480 Gbps
First Junos OS
Release
Supported
12.1x48
35