Installing the Open-Frame Rack Mounting Shelf
Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing the PTX5000 Packet Transport Switch Mounting Hardware
Before mounting the chassis in an open-frame rack, you must first install the open-frame
rack mounting shelf.
To install the open-frame rack mounting shelf (see
On the rear of each rack rail, partially insert a mounting screw into the highest hole
1.
specified in
Table 28 on page 72
Install the open-frame rack mounting shelf on the rack. Hang the shelf over the
2.
mounting screws using the keyhole slots located near the top of the shelf flanges.
Partially insert screws into the open holes in the flanges of the open-frame rack
3.
mounting shelf.
Tighten all the screws completely.
4.
Figure 34: Installing the Mounting Hardware for an Open-Frame Rack
Figure 34 on page
for the open-frame rack mounting shelf.
73):
73