List of logic input terminal function settings
Parameter
programmed value
Positive
logic
7
*1: Active when (frequency setting mode selection) = (UP/DOWN from external logic input) is set.
The frequency setup range is from to (upper limit frequency). The acceleration/deceleration time
relative to the set frequency is / while the acceleration/deceleration speed is not switched.
☆ Refer to section 10.5 for details about the input terminal function.
Function
Negative
logic
No function
Forward run command
Reverse run command
Standby
Reset command
Preset-speed command 1
Preset-speed command 2
Preset-speed command 3
Preset-speed command 4
Jog run mode
Emergency stop by
external signal
DC braking command
2nd
acceleration/deceleration
2nd V/F control mode
switching
2nd stall prevention level
Parameter
programmed value
Positive
Negative
logic
logic
PID control prohibition
Forced local from communication
Operation hold (hold of 3-wire
operation)
PID integral/differential clear
PID characteristics switching
Frequency UP
Frequency DOWN
Clear frequency UP/DOWN
Coast stop command
Frequency setting mode terminal
board VI
Command mode terminal board
Parameter editing permission
Forced deceleration command
Parameter editing prohibition
G-6
E6582233
Function
*1
*1
*1