Opening The Terminal Cover; Removing The Power Terminal Cover - Toshiba TOSVERT VF-nC3E Instruction Manual

1.3.2
 When removing and installing the terminal cover with a screwdriver, be sure not to scratch your hand
 Pressing too hard on the screwdriver may scratch the inverter.
Mandatory
 Always cut the power supply when removing the wiring cover.
1
action
 After wiring is complete, be sure to replace the terminal cover.
Use the following procedure to remove the power terminal block covers.
(1) Removing the power terminal cover (VFNC3E-4004P, 4007P)
1)
Insert a screwdriver or other thin object into the
hole indicated with the
3)
While pressing on the screwdriver, rotate the
screwdriver to right and rotate the terminal
cover downward to remove it.

Opening the terminal cover

as this results in injury.
 Use the small sized flat-blade screwdriver for control circuit terminal
mark.
★ After wiring is complete, be sure to restore the terminal cover to its original position.
Caution
2)
Press in on the screwdriver.
4)
Pull the terminal cover up at an angle.
A-6
E6582233