Input Terminal Function; Settings For The Logic Input Terminal Function; Applied Operations By An I/O Signal (Operation From The Terminal Block - Toshiba TOSVERT VF-nC3E Instruction Manual

7.2 Applied operations by an I/O signal (operation from
the terminal block)
7.2.1
This function is used to send a signal to the input terminal from an external programmable controller to operate or
configure the inverter.
The ability to select from a variety of functions allows for flexible system design.
[Control terminal board]
7
 Settings for the logic input terminal function
Terminal
symbol
F
R
S1
S2
VI
Note 1) Multiple functions assigned to a single terminal operate simultaneously.
Note 2) In case of setting always active function, assign the menu number to  and  (always active
function selection).
Note 3) When VI is used for the logic input, always connect a resistor between VI and terminal P24 in sink logic,
between VI and terminal CC in source logic. Refer to section 2.3.2 (page B-12) for details.

Input terminal function

FLA FLB FLC
OUT NO CC F
Title Function
 Input terminal selection 1A (F)
Input terminal selection 1B (F)

Input terminal selection 1C (F)

Input terminal selection 2A (R)

Input terminal selection 2B (R)

Input terminal selection 2C (R)

Input terminal selection 3A (S1)

 Input terminal selection 3B (S1)
 Input terminal selection 4A (S2)
 Input terminal selection 4B (S2)
Analog/logic input

Selection (VI terminal)
 Input terminal selection 5 (VI)
CC VI P5 FM
R S1 S2 P24
Adjustment range
0-201 Note 1)
0-201 Note 1)
0-201 Note 1)
0-201 Note 1)
0: Voltage signal input (0 - 10 V)
1: Current signal input (4 - 20 mA)
2: Logic input
3: Voltage signal input (0 - 5 V)
8-55 Note 3)
G-2
E6582233
Default setting
2 (F)
0 (No function)
0 (No function)
4 (R)
0 (No function)
0 (No function)
10 (SS1)
0 (No function)
12 (SS2)
0 (No function)
0
14 (SS3)