Switching According To Terminal; Acceleration/Deceleration Pattern Setting; Parameter Configuration Method - Toshiba TOSVERT VF-nC3E Instruction Manual

2) Switching according to terminal (switching acceleration/deceleration time by
external terminal)
Output frequency [Hz]
Second acceleration/deceleration
selection signal
6
 Parameter configuration method
Title

Setting value 25 is reverse signal.

6.17.2 Acceleration/deceleration pattern setting

 :Acceleration/deceleration 1 pattern
 :Acceleration/deceleration 2 pattern
 Function
Select a acceleration and deceleration pattern appropriate for the application.
[Parameter setting]
Title


0
(1)
(1) Acceleration at ramp of
acceleration time 
(2) Acceleration at ramp of
acceleration time 
a) Method of operation from terminal input
Set run operation selection  to  (terminal block).
b) Set the second acceleration/deceleration switching to any input terminal.
The following shows an example of setting to input terminal S2.
Function
Input terminal selection 4A (S2)
Function
Acceleration/deceleration 1 pattern
Acceleration/deceleration 2 pattern
(2)
(3) Acceleration at ramp of
deceleration time 
(4) Acceleration at ramp of
deceleration time 
Adjustment range
0  201
Adjustment range
0: Linear
1: S-pattern 1
2: S-pattern 2
F-46
E6582233
Time [s]
(3) (4)
ON
OFF
Setting
24: AD2 (2nd
acceleration/deceleration)
Default setting
0
0