How To Run And Stop; Run And Stop Using The Panel Keypad - Toshiba TOSVERT VF-nC3E Instruction Manual

3.1.1

How to run and stop

[Example of a  setting procedure]
Panel operation LED display
MODE


(1) Run and stop using the panel keypad (=)
Use the RUN and
: Motor runs.
RUN
The direction of rotation is determined by the setting of parameter  (forward run, reverse run
☆
selection). (: forward run, : reverse run)
To switch between forward run and reverse run from the extension panel (option), the parameter 
☆
(forward run, reverse run selection) needs to be set to  or . (Refer to section 5.7)
(2) RUN / STOP by means of an external signal to the terminal board (=):
Sink (Negative) logic
Use external signals to the inverter terminal board to start and stop the motor.
Short and terminals: run forward
F CC
Open and terminals: slow down and stop
F CC
Displays the operation frequency (operation stopped).

(When standard monitor display selection = [Operation frequency])
Displays the first basic parameter [History ()].

Turn the setting dial, and select "".
Press the center of the setting dial to read the parameter value.

(Standard default: ).
Turn the setting dial to change the parameter value to  (terminal block).

Press the center of the setting dial to save the changed parameter.
 and the parameter set value are displayed alternately.
keys on the panel keypad to start and stop the motor.
STOP
: Motor stops.
STOP
C-3
Operation
Frequency
F-CC
E6582233
Slow down
and stop
ON
OFF
3