Standard Setting Mode; Basic Parameters; Extended Parameters - Toshiba TOSVERT VF-nC3E Instruction Manual

Standard setting mode

4
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
［Basic parameters］



*(Command mode selection)
［Extended parameters］
 to 
 to 
 , 
 to 

 , , ,  


* and can be changed during operation by setting =.
: The mode changes to the Standard setting mode when
the EASY key is pressed and "" is displayed.
Both basic and extended all parameters are displayed.

Basic parameters

Extended parameters : The parameters for detailed and special
(Guidance function)
(Automatic acceleration/deceleration)
(Torque boost setting macro function)
: This parameter is a basic parameter for the
operation of the inverter.
 Refer to chapter 5 for details.
 Refer to chapter 10.2 for parameter tables.
setting.
 Refer to chapter 6 for details.
 Refer to chapter 10.3 for parameter tables.
*(Frequency setting mode selection)

(Maximum frequency)

(V/F control mode selection)

(Default setting)

 to 
 , 
 to 
, , ,
 to 
, 
D-4
E6582233