Kyocera ECOSYS M2135dn Service Manual page 306

U407 Adjusting the writing timing (Duplex/Reversal)
(Message: WR DR Timing)
Contents
Adjusts the writing timing when duplex printing.
Purpose
Adjusted when the back page image of duplex copying is printed in rotated 180 degrees from the
scanner reading image (image on the memory)
Precautions
Adjust this after finishing the following maintenance modes.
U034(6-23) > U402(6-47) > U66(6-26)>
U403(6-48) > U71(6-30) > U404(6-49) > U407
Adjustment
1.Press the [Start] key.
2.Press the [System Menu] key.
3.Place an original on the DP and press the [Start] key to make a test copy.
4.Press the [System Menu] key.
5.Select [Adj Data].
Items
Adj Data
6.Press the [◄] or [►] keys or the numeric keys to change the setting value.
In the case of the copy example 1, raise the setting value.
In the case of the copy example 2, lower the setting value.
* :When the setting value is increased, the image moves forward, and it moves backward
when the setting value is decreased.
7.Press the [Start] key to set the setting value.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents
Adjusts the leading edge timing when
writing the image in the memory
Leading edge registration of the copy image (+1.0/-1.5 mm or less)
Original
Figure 6-17
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA
Setting range
-47 to 47
Copy
Copy
example 2
example 1
6-51
Initial Data
setting varia-
tion
0 1dot