Kyocera ECOSYS M2135dn Service Manual page 255

Error code
Code
0000 Others
0100 There is no master file.
0200 Master file version mismatch.
03xx*4 There is no download file (No.xx).
04xx*4 File (No.xx) check sum discrepancy
05xx*4 File (No.xx) preparation failure
06xx*4 File(No.xx) size excess
08xx*4 File (No.xx) writing failure
*1: The expiration of the FM certification is also included.
*2: Since the normal start-up is available next time, it is restarted automatically and starts up normally.
*3: Since the normal start-up is not available next time, it is not restarted automatically but moved to the USB
update mode.
*4: The identifier applicable to the code XX is as follows.
Update target
Controller data
Optional language data
Engine PWB
The signature verification result display
Official signature verification file
Both certificate and signature files exist and verification is suc-
cessful.
Both certificate and signature files exist but verification is unsuc-
cessful.
Neither certificate nor signature files exist.
Or either of them does not exist.
10. Unplug the power cord and disconnect the USB memory.
11. Plug in the power cord and turn the power switch (a) on.
12. Check that the "Home" screen is displayed and then turn the power switch (a) off.
Precautions
Never turn the power switch (a) off or disconnect the USB memory (b) during the firmware update.
Safe-Update
When the firmware update was interrupted by power shut-off or disconnecting the USB memory during the
firmware update, the firmware update is retried at the next power-on.
Turn the main power on again while the USB memory is installed.
*: The firmware update that was already completed before power shut-down is skipped.
Error contents
Code
01
02
03
04
05
01
01
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA
Code
S000 Other signature verification error *1
S001 The signature verification file is insuffi-
cient.
N001 Unable to connect the network *2
(There is no target under the update.)
N002 can not connect to the network *3
(There is the target to update.)
Identifier
BOOT
KERNEL
FDTBIN
ROOTFS
APPLI
M_OPT_ALL
ENGN
Indicate the result
Version number
5-9
Error contents
S000
S001