Router Installed In The Rack With Etsi Brackets - Juniper MX204 Hardware Manual

MX204 3D Universal Edge Router Hardware Guide
Related
Documentation
70
Install mounting screws into each of the open rear-mounting holes aligned with the
10.
rack, starting from the bottom, and secure them tightly.
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
11.
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the router is level.
router fully secured and installed in a four-post rack with ETSI brackets.
Figure 32: Router Installed in the Rack with ETSI Brackets
MX204 Site Preparation Checklist on page 35
MX204 Router Grounding Specifications on page 30
MX204 Router Clearance Requirements for Airflow and Hardware Maintenance on
page 34
Tools and Parts Required for MX204 Router Grounding and Power Connections on
page 71
Tools Required to Install the MX204 Chassis in Rack on page 64
Figure 32 on page 70 shows the
Copyright © 2018, Juniper Networks, Inc.