Juniper MX204 Hardware Manual page 61

MX204 3D Universal Edge Router Hardware Guide
74
Connect the power cord to the power supply source.
4.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated customer-site circuit breaker. We recommend that
you use a dedicated customer-site circuit breaker rated for 20 A (110 VAC)
or 16 A (220 VAC) minimum, or as required by local code.
Push the end of the AC power cord retainer strip into the hole next to the inlet on the
5.
power supply face plate on the router until it snaps into place. Ensure that the loop
in the retainer strip faces toward the power cord.
Figure 35 on page 74 shows the port on the AC power supply module where the power
cord retainer is installed.
Figure 35: Power Cord Retainer Port on the AC Power Supply Module
1
2
3
1— Input status LED
2— Output status LED
3—Fault LED
Figure 36 on page 75 shows the power cord retainer installed on the AC power supply
module.
4
5
4— Ejector lever
5— AC power cord retainer port
Copyright © 2018, Juniper Networks, Inc.