MX204 3D Universal Edge Router Hardware Guide
Related
Documentation
88
To connect the router to a BITS external clocking device:
Attach an electrostatic discharge (ESD) grounding trap on your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the RJ-45 cable into the internal clock port on the craft interface.
2.
Plug the other end of the RJ-45 cable into the BITS external clocking device.
3.
Verify that the LEDs for the
4.
Configure the port. See Configuring Clock Synchronization Interface on MX Series Routers.
5.
Table 38: BITS Port on the MX204 Router
Callout
3
(See
Figure 39 on page
84)
MX204 Routing Engine Description on page 15
Prevention of Electrostatic Discharge Damage on page 156
BITS
port are lit steadily green.
Label
Description
BITS
Building-Integrated Timing Supply
(BITS) clock interface port with LED.
Copyright © 2018, Juniper Networks, Inc.