Replacing Transceivers; Replacing A Sfp+ Transceiver; Removing An Sfp+ Transceiver - Juniper MX204 Hardware Manual

CHAPTER 18

Replacing Transceivers

Replacing a SFP+ Transceiver

Removing an SFP+ Transceiver

Copyright © 2018, Juniper Networks, Inc.
Replacing a SFP+ Transceiver on page 105
Replacing a QSFP28 Transceiver on page 107
Small form-factor pluggable plus transceivers (SFP+) are enhanced SFP transceivers
that provides support for data rates of up to 10 Gbps for fiber-optic or copper interfaces.
SFP+ transceivers are hot-insertable and hot-removable. Removing an SFP+ transceiver
does not interrupt router functioning, but the removed SFP+ transceiver no longer receives
or transmits data.
Figure 52: Small Form-Factor Pluggable (SFP) Transceiver
Connector
Locking pin
Removing an SFP+ Transceiver on page 105
Installing a SFP+ Transceiver on page 106
To remove an SFP+ transceiver:
Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat,
1.
and a rubber safety cap for the transceiver.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Label the cables connected to the transceiver so that you can reconnect them correctly
3.
later.
105