Installing The Front Etsi Brackets; Installing The Router In A Four-Post Rack - Juniper MX204 Hardware Manual

MX204 3D Universal Edge Router Hardware Guide
68
To install the router in a 21-in. ETSI rack or cabinet:
Position the router in front of the rack or cabinet.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and to a
2.
site ESD point.
Align the holes in the front mounting brackets with the holes on the side of the chassis
3.
(see Figure 26 on page
Figure 26: Attaching the Mounting Brackets
Install the two front ETSI brackets on the front-mounting brackets on each side of
4.
the chassis (see Figure 27 on page
Figure 27: Installing the Front ETSI Brackets
With one person on each side, hold on to the bottom of the chassis and carefully lift
5.
it so that the mounting brackets contact the rack rails.
Carefully slide the router onto the mounting brackets until the front-mounting brackets
6.
attached to the chassis contact the rack rails (see
Figure 28: Installing the Router in a Four-Post Rack
68).
68).
Figure 28 on page 68).
Copyright © 2018, Juniper Networks, Inc.