Juniper MX204 Hardware Manual page 69

MX204 3D Universal Edge Router Hardware Guide
Related
Documentation
82
An RJ-45 to DB-9 rollover cable to connect the external management device to the
console port
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To power off the router:
Connect a management device to the console (see
1.
to External Devices and Cables" on page
On the external management device connected to the Routing Engine, issue the
2.
command.
request system halt
user@host> request vmhost halt
Halt the system ? [yes,no] (no) yes
You see the following output (or something similar) after entering the command:
Initiating vmhost halt... ok
Initiating Junos shutdown...
Shutdown NOW!
ok
Junos shutdown is in progress...
*** FINAL System shutdown message
System going down IMMEDIATELY
...
...
Operating system halted.
Please press any key to reboot.
Wait until a message appears on the console confirming that the operating system
3.
has halted. For more information about the command, see the
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
4.
ESD points on the chassis.
Switch off the power supply source.
5.
Powering On an AC-Powered MX204 Router on page 76
Powering On a DC-Powered MX204 Router on page 80
request vmhost halt
"Connecting the MX204 Router
83).
shutdown: [pid 14318]
***
Copyright © 2018, Juniper Networks, Inc.
.
CLI Explorer