Overview Of The Service Menu; Commissioning; General Commissioning Of The User Interface - Bosch HPC 400 Installation Instructions For Contractors

COMMISSIONING
~
BOSCH
4.4 Overview of the service menu
- - - - - - - -
heater
System data
cooling
Priority heating
DHW settings
complete
Diagnosis
Table
9
Overview of the service menu
5 COMMISSIONING
and.ifnecessary. adjustthe ----rortheauxiliaryheater:-- - - - - - - - -
-~
15
The settings that apply to the entire heating system. e.g. minimum outside temperature and building type. This 17
menu contains additional settings for heating/cooling circuit 1.
Heating circuit 1 determines how the system behaves. If there is no heat requirementfor heating circuit 1. no heat 18
requirements for other circuits are handled either.
ng Circuit-specific settings for installed heating/cooling circuits 1 to 4. e.g. frost protection and 18
and save settings.
-
- - - - - - - - -
System diagnosis:
I
' .
Perform function test of individual actuators (e.g. pumps) .
Compare set and actual values.
Call up current faults and the fault history.
Call up the software versions of all BUS nodes.
Additional functions:
Enter contact address.
• Reset different settings.
and configuration
26
26
• Calibrate the time.
---------~
5.1
General commissioning of the user interface
[I]
Before comissioning:
1
~
Turn on and set coding correctly on all additionally
installed modules (-7 Technical documentation of
the particular module) .
&
,CQ)'
~
Turn the selector to set whether a buffer cylinder is installed
or not and then press the selector to confirm.
~
Turn and press the selector to start (Yes) or to skip the
configuration wizard
(No).
~
When the configuration wizard is started. the user interface
I
automatically recognises which BUS nodes are installed in the
system (system analysis) and adjusts the menu and the
I
factory defaults to the current system.
J
~ Perform system commissioning (~Chapter 5.2) .
Table 10 General settings at commissioning
8 HPC~OO - G -2082 1 772 (2017107)