Configuring Settings to Match the Properties of the Media
Adjusting Print Head Height to Match Media Thickness
Procedure
A
Press [MENU].
B
Press [ ] several times to display the screen shown below.
MENU
HEAD HEIGHT
C
Press [ ] to display the screen shown below.
HEAD HEIGHT
HIGH
D
Open the front cover.
E
Move the height-adjustment lever to adjust the print head height.
When you change the position of the height-adjustment lever, the display screen will change.
4
When the lever is moved to the "High" direction, the buzzer sounds twice. When it is moved to the
"Low" direction, the buzzer sounds once.
M E M O
Normally move the height-adjustment lever to "Low." For media that is wrinkled or comes loose
from the platen, move the height-adjustment lever to "High."
F
Press [ENTER] to confirm your entry.
G
Close the front cover.
H
Press [MENU] to go back to the original screen.
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
128
LOW
Height-adjustment lever
Move firmly, until it stops.
HEAD HEIGHT
LOW
HIGH
HEAD HEIGHT
LOW
LOW