Table of Contents
Advertisement
On-Site Adjustments
Table 9-2 Circuit Card Replacement Procedure (VPR100 & VRX100)
Step
1
Place the rear of the card cage assembly into the opening. Lift it up and over the limit stop, then
push it all the way back into the housing.
2
Press the unit back to fully engage the rear card edge connectors and until both front latches snap
into place and the PC molding is flush with the sub-bezel. See Figure 9-1.
3
Pull on the lower bail linkage to verify that the unit is fully seated and firmly latched, then close the
front display assembly. Engage the top edge of the bezel first, then swing in the bottom and press it
in until the button latch snaps into place.
264
Palm face up, insert three fingers
here and pull out sub-chassis.
Latches
Push toward center of
instrument to release
Figure 9-1 Circuit Card Removal (VPR100 & VRX100)
VPR & VRX – User Manual
Bail linkages
Sub-bezel
PC Molding
Action
12/00
Advertisement
Table of Contents
