Table 6-9 Messages And Symbols Elsewhere On Display - Honeywell VPR100 User Manual

Table 6-8 Messages and Symbols at Bottom of Display (continued)
Message/Symbol
GENERAL ERROR
S
Z
H
Message/Symbol
REVIEW or REPLAY
*
or
Flashing between ******
and value
Flashing between value
and blank
Flashing between value
and blank
12/00
Color
Yellow This message will appear if the instrument encounters any error not
mentioned above.
Yellow Located in bottom right of display. Indicates storage is active data is
being collected on disk or in the instrument's internal buffer.
White Located in bottom right of display. The display's upper and lower
limits are zoomed on a smaller range. Disappears when Zoom is
turned off.
White Located in bottom right of display. Indicates the display is held on a
single data point and is not rotating through all data points.
Disappears when Point Hold is removed.

Table 6-9 Messages and Symbols Elsewhere on Display

Color
White
Trend Replay/Review. Adjacent to detailed point information
(scoreboard) on the screen. Indicates that the trend on the display
is from historical data and does not represent the current state of
the process. REVIEW means that the data for the trend are from
current memory (RAM). REPLAY means that the data are retrieved
from floppy disk (data storage).
White
Analog Input Value Adjust. Located to the right of the data point
value. This message appears only on the AI Value Adjust display. It
indicates that a bias has been manually applied to the value of the
particular data point. The symbol will disappear when the value is
set to OFF.
Red
Low Alarm Setpoint. Located above vertical trends, right of
horizontal trends, along side of bar graph. These symbols appear
automatically if a displayed point is the input to one or more Alarm
function blocks. The first 4 low type alarm blocks using the
displayed points are represented by these symbols.
Red
High Alarm Setpoint. Located above vertical trends, right of
horizontal trends, or along side of bar graph. These symbols
appear automatically if a displayed point is the input to one or more
Alarm function blocks. The first 4 high type alarm blocks using the
displayed points are represented by these symbols.
Same as
Bad Input Values. Appears in place of the value on all displays.
data point
Value is outside the programmed limits. Caused by an upstream AI
failure (AI is open circuit and failsafe or is type linear and outside its
programmed range by 10% or more).
Same as
Questionable Input Values. Appears in place of the value on all
data point
displays. Value is clamped at its limit.
Same as
Output Limits of Totalizer or Interval Timer Exceeded. Appears in
data point
place of the value on all displays. Interval Timer's or Totalizer's
value is outside its output limits. Value is not clamped.
VPR & VRX – User Manual
Online Operations Using Primary Displays
Description
Description
231