Access To Floppy Drive, Keyboard/Barcode Reader Connection; Table 3-3 Front Bezel Open/Close Procedure; Figure 3-9 Access To Connector And Floppy Drive (Vpr100 & Vrx100) - Honeywell VPR100 User Manual

Programming and Operating Concepts

3.7 Access to Floppy Drive, Keyboard/Barcode Reader Connection

VPR100 & VRX100 Access
To connect a QWERTY keyboard or barcode reader, to remove or install a floppy disk, or to access the
inside of the instrument, open the front bezel as described in Table 3-3.
Step
1 While pressing the bottom of the bezel inward, press the button on the underside of the bezel to
release the latch.
2 Pull the bottom of the bezel outwards slightly away from the panel and then lift it gently to fully open
it as shown in Figure 3-9.
3 Close the bezel by releasing the bezel release lever and lowering the bezel with the bottom held
slightly out. Engage the top edge of the bezel first and then swing the bottom inward toward the
panel. Press the bottom in firmly until the latch clicks into place. Close the bezel securely or storage
to disk will not operate properly.
Figure 3-9 Access to Connector and Floppy Drive (VPR100 & VRX100)
46

Table 3-3 Front Bezel Open/Close Procedure

Action
VPR & VRX – User Manual 12/00