Setpoint Profiler
How to hold a profiler
Step
1
Perform steps 1 and 2 from Start procedure
(Table 5-13).
2
Press Down Arrow button to move cursor to
Hold. Press Enter.
ATTENTION
A profile can also be put on HOLD by pressing the HOLD or F2 button, but only if that profile's HOLD
parameter was configured as SY1 F2 and if that profile's HOLD LEVEL/EDGE is set to EDGE. See Section
5.3.
How to reset a profiler
Step
1
Place profiler in Hold.
1
Perform steps 1 and 2 from Start procedure
(Table 5-13).
2
Press Down Arrow button to move cursor to
Reset. Press Enter.
ATTENTION
A profile can also be RESET by pressing the RESET or F3 button, but only if that profile's RESET/RUN
parameter was configured as SY1 F3. See Section 5.3.
214
Table 5-14 Profiler Hold Procedure
Action
Table 5-15 Profiler Reset Procedure
Action
VPR & VRX – User Manual
Result/Notes
Profile menu is displayed.
The profiler is held at its present value and the
segment's events are frozen. Elapsed time
continues. Run time stops. Events are held at
their current states.
Result/Notes
See Profiler Hold procedure in Table 5-14.
Profile menu is displayed.
Profiler is reset to segment #1. All profiler timers
are reset. All events go OFF. Profiler output
goes to starting value of segment #1.
12/00