Connecting
5.4 Wiring the power supply and modules
Installing the Shield Contact Element
Install the shield contact element as follows:
1. Push the two bolts of the fixing bracket into the guide on the underside of the rail. Position
2. Bolt the fixing bracket tight to the rail.
3. A slotted web is arranged at the bottom side of the terminal element. Place the shield
4. Press the shield terminals down and swing them into the desired position.
①
②
86
the fixing bracket under the modules to be wired.
terminal at this position onto the edge of the fixing bracket (see the figure).
2
1
2
You can attach up to four terminal elements on each of the two rows of the shield contact
element.
2
Figure 5-4
Placing shielded 2-wire lines on the shield contact element
Fixing bracket
Shield terminals
1
Operating Instructions, 12/2008, EWA-4NEB780600602-08
ET 200M