Siemens SIMATIC ET 200M Operating Instructions Manual page 243

Compatibilities between the IM 153-x
This chapter includes the most important information that you must know if you are
"changing over" from an old IM 153-x to a new or different IM 153-x.
A.1 Compatibilities between the versions of IM 153 and IM 153-1
The versions of IM 153-1
Table A- 1 Properties and variants of the IM 153-1
Functions / properties
Min_slave_interval between two slave list cycles
SYNC, FREEZE
Module change during operation
Direct data exchange
Enhanced diagnostics
64 byte diagnostic frame
•
Extended range of environmental conditions
(outdoors)
RC network with 10 MΩ for unearthed configuration
DPV1-mode
E = module version
Compatibility between 153-1AA00- and 153-1AA01-...
The IM 153-1, order number 6ES7153-1AA01-0XB0 is partially upwards compatible. This
means that the configuration and the user programs for the IM 153-1, order number
6ES7153-1AA01-0XB0 can also be used for the IM 153, order number
6ES7153-1AA00-0XB0, apart from if you are working with SYNC and FREEZE in these user
programs. Note also the different min_slave-intervals (refer to table above).
Retrofitting to 153 1AA02 ...
The IM 153-1 with order number 6ES7153-1AA01-0XB0 can be retrofitted to the IM 153-1
with order number 6ES7153-1AA02-0XB0.
Contact your Siemens representative for this.
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
Interface module with order number
00 01
1 ms 0,1 ms 0,1 ms
– x
– –
– – as of E07
– –
– –
- - as of E08
(1 MΩ) (1 MΩ)
– –
6ES7153-1AA..
02 03 82
0,1 ms 0,1 ms
x x
x x
x as of E06
– x
as of E02
– –
x as of E07
– as of E05
A
83
0,1 ms
x x
– –
x
– x
x x
x
– as of E03
241