Siemens SIMATIC ET 200M Operating Instructions Manual page 36

Assignment planning
3.1 Structure variants for PROFIBUS DP
Structure variants in the outdoor area
Using the existing hardware you can realize the combinations listed in the following table in
the outdoor area.
Table 3- 2
non-redundant configuration
•
•
* SIPLUS modules for use in expanded environmental conditions
In the table, IM 153-2 stands for IM 153-2 (6ES7153-2BA81-0XB0 or 6ES7153-2BA82-0XB0)
SIPLUS modules
For the outdoor area under the product names SIPLUS special S7-300 modules are
available. You can use these under expanded environmental conditions. Expanded
environmental conditions mean:
● can be used from –25 °C to +60 °C
● occasional, brief condensation is permitted
● increased mechanical load permitted
In the functional scope and in the technical data, the SIPLUS modules correspond to the
"standard" modules.
The SIPLUS S7-300 modules have their own order numbers. These are based on those of
the "standard" S7-300 modules, starting however with "6AG1..." instead of "6ES7...".
For more information on these modules, refer to the reference manual "S7-300 automation
system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
You´ll find more information on SIPLUS and contact partners for this area in the Internet
(http://www.automation.siemens.com/siplus/index_76.htm).
Reference
● You´ll find detailed information regarding the functions and properties of the IM 153-2 in
● You´ll find detailed information on mechanical and climatic environmental conditions for
● The IM 153-2Bxx1 is not just an interface module for the ET 200M, but also for the bus
See also
Compatibilities between the IM 153-x (Page 241)
34
ET 200M structure variants in the outdoor area
IM 153-2 + bus connector
+ I- / O-modules*
BM IM/IM (7HD80) + IM 153-2
+ BM 2 x 40 / BM 1 x 80 (painted) *
+ I- / O-modules*
chapter "Functions (Page 129)" and in the appendix "Functions (Page 129)".
operating the ET 200M in chapter "General technical specifications of the reference
manual "S7-300 automation system, module specifications
(http://support.automation.siemens.com/WW/view/en/8859629)".
connections DP/PA-link and Y-link. For the configuration variant options please refer to
the "DP/PA Link and Y Link bus links
(http://support.automation.siemens.com/WW/view/en/1142696)" operating instructions.
redundant configuration
BM IM/IM (7HD80) + 2x IM 153-2
•
+ BM 2 x 40 / BM 1 x 80 (painted) *
+ I- / O-modules*
Operating Instructions, 12/2008, EWA-4NEB780600602-08
ET 200M