Siemens SIMATIC ET 200M Operating Instructions Manual page 102

Commissioning
6.2 PROFINET IO
6.2.4 Configuring ports of the IM 153-4 PN
Introduction
The IM 153-4 PN interface module can diagnose both of its ports: X1 P1 and X1 P2.
Requirement
● The ports must be configured in HW Config.
● The port diagnostics must be released.
Configuring ports in HW Config
Configure both ports of the IM 153-4 PN in HW Config in the "Properties of the IM 153-4 PN
port..." dialog:
● Addresses tab:
● Topology tab:
● Options tab:
Reference
See
100
Specify the diagnostic address of each port.
Specify a "Port interconnection".
To enable the port diagnostics, select the following for "Connection" under "Transmission
Medium / Duplex": "Automatic Settings (monitor)".
STEP 7
Online Help.
Operating Instructions, 12/2008, EWA-4NEB780600602-08
ET 200M