Siemens SIMATIC ET 200M Operating Instructions Manual page 85

Wiring front connectors
Table 5- 3 Wiring front connectors
Step
1. Thread the cable strain relief assembly into the
front connector.
2. Do you want to bring the cables out at the bottom of the module?
If so:
Start with terminal 20 and wire the terminals in the
sequence terminal 20, 19, .... until you get to 1.
If not:
Start with terminal 1 and wire the terminals in the
sequence terminal 1, 2, .... until you get to 20.
3. Also tighten the screws of any terminals that are not wired.
4.
5. Pull the cable strain relief assembly tight. Push the retainer on the strain relief assembly in to the left; this will
improve utilization of the available space.
—
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
20-pin front connector
–
2
1
5.4 Wiring the power supply and modules
40-pin front connector
Start with terminal 40 or 20 and continue to wire the
terminals reciprocally, i.e. the terminals 39, 19, 38, 18, etc.
until terminals 21 and 1.
Start with terminal 1 or 21 and continue to wire the
terminals reciprocally, i.e. the terminals 2, 22, 3, 23, etc.
until terminals 20 and 40.
Thread the cable strain relief assembly into the front
connector.
2
1
3 4
Connecting
–
83