Siemens SIMATIC ET 200M Operating Instructions Manual page 124

Maintenance and service
7.10 Updating the IM 153-x
7.10.4 How to update the IM 153-2Bxx1
Where can I obtain the latest firmware version?
You can order the latest firmware from your Siemens partner, or download it from the
Internet
search_p/index.ad.nwa.EN.html?q=15350678).
Tip:
● Prior to the update note down the current version of your firmware.
● If you encounter problems with the new firmware, you can also download the previous
Principle
Updating an IM 153-2 as of order number 6ES7153-2Bxx1-0XB0 depends on the
configuration of the IM 153-2:
Configuration as IM 153-2Ax0x
The update is carried out from the PD / PC via the PROFIBUS DP (direct) and is conducted
via the online view (available nodes) in
is directly connected to the PROFIBUS interface of the IM 153-2.
Configuration as IM 153-2Bx00
There are two ways in which you can perform an update:
● from PD / PC via PROFIBUS DP (direct)
● from PD / PC via PROFIBUS DP and CPU
You will require
Configuration as IM 153-2Bxx1
There are two ways of updating:
● from PD / PC via PROFIBUS DP (direct)
● from PD / PC via PROFIBUS DP and CPU
You will require
After a successful update the former firmware version of the IM 153-2 must be covered over
with a sticker showing the updated version of the firmware.
With the interface modules IM 153-2Bxx1-0XB0 it is possible to update the firmware of both
interface modules while the redundant mode is running. The update takes place with support
from
system is updated from the PD / PC via PROFIBUS DP (direct).
122
(https://portal.automation.siemens.com/apps/meta-
(current) firmware from the Internet and transfer it to the interface module again.
STEP 7
(V5.2 or higher) for this purpose.
STEP 7
(V5.4 or higher)
STEP 7
and has no interaction on the running application. The firmware in a redundant
STEP 7
. To do this, the PG / PC with the update files
Operating Instructions, 12/2008, EWA-4NEB780600602-08
ET 200M