Siemens SIMATIC ET 200M Operating Instructions Manual page 247

Configurable FM in a configuration with IM 153-2
For the distributed use of the FM 353 / 354 / 355 with full S7 functionality you can use the
following CPUs and FMs only as of the specified order numbers and module versions.
CPUs and FMs not listed in the table (e.g. CPU 316-2 DP) can be used as of the respective
first module version.
Table A- 2 Restrictions for DP master CPUs and FM for IM 153-2
Module
CPU 315-2 DP
CPU 413-2 DP
CPU 414-2 DP
CPU 416-2 DP
FM 353
FM 354
FM 355C
FM 355S
Configuration of the IM 153-2 with the general ID format (AKF)
You can also configure the IM 153-2 as of order number 6ES7153-2AA02-0XB0, module
version 07, and 6ES7153-2AB01-0XB0, module version 06, with the general ID format AKF.
This configuration assumes detailed knowledge of the structure of the AKF. You must use
the code 0x00 for the slots 1 to 3.
If you conduct the configuration with the general ID format AKF, the quality of the
comparison of the preset and actual configuration when the DP slave starts up or when
removing or inserting modules is very low. Since there is no type ID available for the
comparison, an incorrect configuration cannot be easily detected!
Functionality of the Previous Version
If you insert the IM 153-2Bx00 interface module
● on a bus module BM IM/IM (6ES7195-7HD00-0XA0),
● configure as an IM 153-2AA02 / -2AB01 with
● configure with GSD revision 2,
then it has the functionality of an IM 153-2AA02 / -2AB01.
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
as of order no.
6ES7315-2AF01-0AB0
6ES7413-2XG01-0AB0
6ES7414-2XG01-0AB0
6ES7414-2XJ00-0AB0
6ES7416-2XK00-0AB0
6ES7416-2XL00-0AB0
6ES7353-1AH01-0AE0
6ES7354-1AH01-0AE0
6ES7355-0VH10-0AE0
6ES7353-1VH10-0AE0
WARNING
A.2 Compatibilities between the versions of IM 153-2 / -2 FO
... with module version
03
02
02
04
04
04
01
01
01
01
STEP 7
Compatibilities between the IM 153-x
Operating system update is
possible as of version module
01
01
01
03
03
03
–
–
–
–
,
245