Siemens SIMATIC ET 200M Operating Instructions Manual page 272

Index
Isochronous, 168
Optimizing the equidistant time, 170
Overlapping of Ti and To, 169
Requirements, 169
Isolated modules, 57
J
Jumper, 79
L
Labeling strip, 84
LED display
IM 153-4 PN, 218
LEDs
IM 153-1, 185
IM 153-2, 186
IM 153-2 FO, 186
Load power supply
Properties, 51
Location of the modules, 43
M
Machinery directives, 47
Maintenance, 103
Maintenance interrupts, 222
Manual
Order Number, 249
Manufacturer ID, 197
Marine
Certification, 228
Master PROFIBUS address, 196
Maximum configuration
exceeded, 223
Module change during operation
configuration rules, 44
Module insertion interrupt, 206, 215, 216
Module removal interrupt, 206, 215, 216
Module status, 199
modules
identification with slot numbers, 68
isolated, 55, 57
Modules
number in installation setup for module change
during operation, 46
Number in the standard configuration, 43
open, 59
Mounting
of the ET 200M, 59
270
Mounting rail, 15
Connection of protective conductor, 63
fixing holes, 61
for active bus modules, 15, 60
for module change during operation, 60
Installing, 60
lengths, 42
N
Network
PROFIBUS DP, 12
Node flash test, 99
Number wheel, 68
O
Open modules, 59
Operating instructions
Changes since the previous manual, 4
Order number, 234
Order numbers
for accessories, 247
of the IM 153, 3
Output delay, 240
Overall configuration
in the TN-S-network, 52
P
Parameter assignment data to intelligent field devices
IM 153-2, 36
Parameter assignment message frame
Look on the Internet under ..., 3, 5
Parameters
IM 153-x, 229
Pin assignment
RJ45 connector, 76
Plug adapters
for the IM 153-2 FO, 73
Order number, 248
PNO Certificate No.:, 228
Ports, 100
Power loss
Controlling, 49
Power supply, 15
Replacing, 103
Wiring, 79
Product version, 3
PROFIBUS address
setting, 69
Operating Instructions, 12/2008, EWA-4NEB780600602-08
ET 200M