Siemens SIMATIC ET 200M Operating Instructions Manual page 103

6.2.5 Commissioning ET 200M for PROFINET IO
Introduction
Your automation system is commissioned depending on the current plant configuration. The
following procedure describes the commissioning of the ET 200M on an I/O controller.
Requirements for the ET 200M on PROFINET IO
Actions
ET 200M installed
ET 200M wired
The SIMATIC Micro Memory Card is inserted
Device name for I/O device assigned
ET 200M configured
Supply voltage to the I/O controller is switched on
I/O controller is switched to RUN mode
Commissioning the ET 200M
1. Switch on the supply voltage for the ET 200 M.
2. If necessary, switch on the supply voltage for the load.
ET 200M
Operating Instructions, 12/2008, EWA-4NEB780600602-08
Note
Changes of the backplane bus
If you change the backplane bus (e.g., number of modules), a Power Off/Power On of the
supply voltage for the ET 200M is required.
Reference
Chapter "Installation (Page 59)"
Chapter "Connecting (Page 71)"
Chapter "Service and maintenance (Page 103)"
Chapter "Commissioning (Page 89)"
Chapter "Commissioning (Page 89)"
I/O Controller Manual
I/O Controller Manual
Commissioning
6.2 PROFINET IO
101