Remote Control; Configuring The Remote Control - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual

3.
4.
5.
A.9.2

Remote control

A.9.2.1

Configuring the remote control

With the remote control function you can perform the following operations:
● Operating the HMI remotely from a computer
● Generating screenshots of the HMI and saving them onto a computer
Note
To use the remote control function of AMM, make sure you enable the communication ports 22 and 5900 on the HMI. For
more information about enabling the communication ports, see Section "Configuring the firewall (Page 42)".
Configuring the remote access rights
Proceed through the following steps to configure the remote access rights on the HMI:
1.
2.
3.
4.
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Copy the program file with the toolbar button
menu.
Select the program directory in the NC file system.
Paste the copied file into the current directory with the toolbar button
V), or from the shortcut menu.
Alternatively, you can transfer the file by simply dragging and dropping it from the PC file system to
the NC file system.
After the file is successfully pasted, you can find it in the corresponding directory on the control
system.
Select the alarm operating area on the PPU.
Press this softkey to change the settings, if desired.
Press this softkey to make the settings changeable. Note that this softkey is visible only with a
system password.
Use this key to select the desired right for remote access. You can choose to allow the remote
operation/monitoring of the HMI, or forbid the remote access to the HMI.
, keyboard shortcuts (Ctrl + C), or from the shortcut
, keyboard shortcuts (Ctrl +
477